Introduction Low-voltage cables for solar lights get nicked by strimmers, boots, and edging tools, and a nicked cable is a dead light and a wasted afternoon of fault-finding. A 3D printed cable guard is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small solar … Read more
Introduction A lantern brought in wet, or one that collects dew overnight, leaves a ring on a wooden table that outlasts the evening it came from. A 3D printed base drip tray is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small solar chargers, … Read more
Introduction A row of path lights that wanders even a little looks accidental, and once the stakes are in, nobody wants to pull them all out and start again. A 3D printed alignment jig is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small … Read more
Introduction Trellis lighting usually means wire ties or tape, which slip, look untidy, and pinch stems when plants grow around them. A 3D printed trellis clip is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small solar chargers, and solar lanterns. It is not … Read more
Introduction String lights hung by eye end up with one span drum-tight and the next drooping onto a bush, and the uneven line is obvious from across the garden. A 3D printed sag gauge is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small … Read more
Introduction Lights in open, windy corners lean a little more after every storm, until the row looks drunk and the panels face anywhere but the sun. A 3D printed wind brace ring is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small solar chargers, … Read more
Introduction Bare ground spikes in a storage box scratch lenses, puncture bags, and prick the hand that reaches in for a light in the dark. A 3D printed spike protector cap is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small solar chargers, and … Read more
Introduction Solar lanterns are carried by their small factory handles, which dig into the fingers on the walk back from the far end of the garden, especially with a heavier lantern. A 3D printed carry handle is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path … Read more
Introduction Lights stored over winter come back dusty, with panels filmed over and lenses scratched by neighbours in the box, so spring starts with a cleaning job. A 3D printed storage dust cover is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small solar … Read more
Introduction Small garden bridges and boardwalks are dark at night, yet their rails are awkward shapes that ordinary light mounts cannot grip without slipping. A 3D printed bridge rail clip is a simple, original holder, mount, or organiser for sealed low-voltage solar products only, such as garden lights, path lights, small solar chargers, and solar … Read more